When a Volume is selected the SELECTION - TOOLS menu will be available. The SELECTION - TOOLS menu contains tools that allow you to annotate, change the styling, or perform advanced functions on the selected Volume item(s). The menu dynamically adjust the tools available depending on your item selection. 


Volume selection



Annotate group


Icon
NameDescription
-
NameVolume Descriptor & Number displayed over the Volume in the Viewport.
-
VolumeDisplays the calculated net volume amount over the Volume item in the Viewport. Volume will be displayed in project units³.
-Cut/FillDisplays the spotted cut and/or fill values over the Volume item in the Viewport. The labels are dropped according to a grid defined by the value entered in the Spacing box. Values will be displayed in the project units.
LabelAllows you to change the Volume Label color.
SizeAllows you to change the Volume Label size.
-SpacingAllows you to change the density of the Cut/Fill labeling.


Transparency group


Icon
NameDescription
-
TransparencyApplies a transparency filter to your Volume colors. This allows you to set how well you can see through the colored area of the Volume, allowing you to see both the Cut / Fill colors, underlying Image, and Surface Terrain. 


Cut/Fill Map group


Icon
NameDescription
-
ColorsAllows you to set the color scheme to display your Volume information. Two color schemes are available to be picked, a simple red or blue, and a color ramp blue to red. Colors display visually where there are Cut & Fill areas. Blue / neon blue areas represent Fill areas, while red / yellow to red represent Cut areas in the Viewport.
-
Min. Cut/FillMinimum Cut/Fill applies a threshold to both the Cut and Fill that does not apply color to values under your threshold. For instance, a Volume area with a 2ft Min Cut/Fill will only show color on areas with Cuts above 2ft, and Fills below -2ft. Anything in between will have no color applied, and will display as normal.
-
Stretch toStretch to allows you to set a threshold for the top and bottom value of the color ramp. Any values above or below the set threshold will then display their color as the maximum of the color ramp.

For example if your maximum cut value is 25 feet due to some outliers such as vegetation or noise in your data, most of your relevant data might have a max Cut & Fill of 10 ft only, and will be either yellow or neon blue (the inner colors of the color ramp), with no dark red or blue (the outer ends) being shown. Adjusting the Stretch to value to 10ft would then color any Cuts above 10ft to the maximum color (red), and any Fills below -10ft to the maximum color (dark blue).
RefreshRecalculates your Cut & Fill calculations based on any changes made to the Surface Terrain such as Clean Terrain, Terrain Modification or Offset.
-
ReferenceAllows you to change the Terrain State you want to use as reference for the Cut & Fill calculation. This feature is activated only if the project contains a Cut/Fill map. After having modified the Terrain State reference, do not forget to recalculate volumes.


Volumes group


IconNameDescription
Recalculate Volume
Updates multiple volume items in one click. Useful if you have modified an elevation terrain.

Result: Volume  
Center of MassCreates a Point at the the center of mass for both the Cut and Fill. This point will be in 3D space and also have a descriptor applied as either Center of Fill or Center of Cut.

Result: Point
Extract Cut/Fill Area
Breaks down a single cut/fill map in its components and determines quantities related to these areas. 

Result: Volume